How To Change A Water Pump On A 2010 Chevy Malibu
How to Install a Water Pump in a Chevy Malibu
by Eli Laurens
static.am-autoparts.com
The Chevrolet Malibu, in its many variations, uses a gasoline engine with a water/antifreeze coolant system. This system uses the drive ability of the motor to button a mechanical water pump, which can wear out over time and require replacement. The average backyard mechanic can replace a water pump in near an 60 minutes.
Step 1
Remove the old water pump. Start by removing the fan belts, if applicable. Next, remove the hoses that adhere to the pump with a pair of pliers (crimping hose clamps), or a screwdriver (screw-fashion clamps). Collect old coolant into the drain pan. The water pump will have three or four big bolts belongings it to the front crankcase that must be removed. One time these bolts are out, the pump volition be freed, and tin be pulled away from the motor.
Step two
Drain the coolant from the organization. Many water pump failures tin can be caused by droppings or sometime coolant that has clogged the old pump, or has lost the ability to absurd effectively. To forbid this from happening to the new pump, fresh coolant must exist added when changing the pump. Malibus have a drain plug on the radiator, unremarkably on the lower left side, that tin be turned counter-clockwise to release the coolant. Collect the onetime coolant into the drain pan.
Footstep 3
Install the new h2o pump. The new pump will come with a gasket that separates the pump from the crankcase, and information technology must exist aligned correctly. Bolt the pump into place, then connect the hoses to their respective locations. Replace the fan belts, if applicable.
Pace 4
Add coolant to the system. Tighten the drain plug, then fill the radiator with coolant. Creepo the engine up, and add coolant to the radiator until information technology cannot take any more. Replace the radiator cap, and add together coolant to the reservoir tank.
Drive the vehicle, and check for leaks.
Tips
- Use distilled water instead of tap water, as it has a higher humid point and volition non corrode parts.
Things You'll Demand
- Socket set
- Drain pan
- Coolant
- Pliers
- Screwdrivers
Warnings
- Do not leave coolant in puddles, as animals often like to potable it.
Writer Bio
Eli Laurens is a ninth-class physics teacher as well as a computer programmer and writer. He studied electric engineering and architecture at Southern Polytechnic University in Marietta, Ga., and now lives in Colorado.
More Articles
Source: https://itstillruns.com/install-water-pump-chevy-malibu-5201967.html
Posted by: phillipsnobjess76.blogspot.com
0 Response to "How To Change A Water Pump On A 2010 Chevy Malibu"
Post a Comment